Have Questions? We are here to help
-
Guaranteed Fitment
Always the correct part
-
In-House Experts
We know our products
-
Added Value
Warranties available
-
Wordwide Delivery
We ship all over the world
Burger Motorsports BMS F Chassis 3.5" Billet N55 & B58 Exhaust Tips (Pair)
Upgrade to Larger 3.5" Angle Cut Billet Tips
Bolting on a custom look with these 3.5" billet exhaust tips for your N55/B58 BMW exhaust outlets. Machined from a solid block of billet aluminum and equipped with set screws so they go on easily and stay in place. No clamps for a clean appearance. Available in Matte Black and Polished Silver. Not for use with M-Performance exhaust systems.
To install remove your factory BMW exhaust tips by pounding outward on the lower part of the tip with either a rubber mallet or a hammer. You can spray some lubricant inside the tip to make it a little easier. A small piece of wood can also be used between the hammer and the exhaust tip edge. This is done from under the rear of the car. Small medium taps will start the factory tip sliding off the actual exhaust pipe. Secure the tip before it comes off the end of the pipe with your hand. Make sure to keep it straight to not damage the inner spring clips. The cutouts in the rear must be facing straight up. Slide the BMS slip-on exhaust tip straight over the factory exhaust pipe. Carefully push the tip straight on until it stops. Then tighten the supplied set screws with an allen wrench. A liquid thread locker is recommended.